22" Height Rigid Steel Edging - Weathering Steel

22" Height Rigid Steel Edging - Weathering Steel

4.5 / 5.0 based on 2 reviews

Customer Reviews

Based on 2 reviews
50%
(1)
50%
(1)
0%
(0)
0%
(0)
0%
(0)
M
Mike Sutton
Good Stuff

I’m excited to work with this product because it is so easy to integrate into different designs. The people and instructions are very helpful. A couple pieces got dinged and bent during shipping, but a hammer and channel locks straightened everything out in no time. Nothing to worry about, everything joined up perfectly in the end. I like it so much I’ve already ordered it again for my next install!

M
Matthew Dempsey
Solid product

Built a DIY retaining wall with the 22” and 15” rigidline edging. Was able to cut and shape easily. Only issue is that I had trouble getting a truly straight line with the 22” height as the metal bowed slightly on the pallets in transit and was tough to bend back perfectly straight. Still very happy with the product and the finished project. Would buy again in the future.

  • Straight lines and geometric designs
  • Raised, straight-sided feature gardens
  • Kitchen garden beds
  • Straight run terraces/retainers
  • Hard surface mounting i.e. rooftops/decking
  • Raised border edging
  • Medium height retainers
  • 22 inch high, 85 inch long sections (7 feet).
  • Joining plates and spiked nails included.
  • 2 mm thick, 8mm top edge.
  • Folded lip, no sharp edges.
  • Weathering Steel Edging arrives prior to rusting occurring and appear in a black/gray color at first. 
  • Rusting time after install will depend on weather conditions in your area.
  • Preformed corners are 10 inches each side of the 90 degree bend.
  • Included with each 7' sections are 5 long twisted nails and the connectors.  Tek screws and driver bit are also included if you are purchasing the anchor posts.
  • Not included is the anchor posts, universal bracing, preformed corners and joining sleeves.
  • See details regarding bracing and joining sleeves below
    • Bracing Kits and anchor posts sold separately as singles.
    • Required in most installations
    • Recommendation is 2 per section min.
    • Choose from large anchor post style or universal bracing turnbuckle style.
    If you choose to go with the anchor posts are installed by tek screwing to the side of the ribs (brackets) on the back of the edging.  The screws are self tapping, and will go into the post without the need for pre-drilled holes.

    • Joining sleeves are only needed if you are cutting the edging (therefore cutting off the built in connections) and then need to rejoin the edging.

      Search

      Search for products